Bent lamination hangers

8th December 2020 — 1 minute read

Simple hangers made by bending and laminating strips of walnut.

Always wanted to have a go at bent lamination and since we needed some hangers for the house I gave it a try.

Bent lamination hangers — Made a simple feather board that doubles as a thin strip jig if you turn it around. Much safer to cut thin strips with.

Bent lamination hangers — Made a form to clamp the 3 mm strips of walnut.

Bent lamination hangers — Shaping was done mostly using the belt sander.

Bent lamination hangers — Drilled some countersunk holes for screws.

Bent lamination hangers — Made another jig where clamping is much easier.

Bent lamination hangers — Ended up with 3 slightly different hangers.

Bent lamination hangers — Tadaa!